• Sockets
• Ext / Adapter
• Multiplier
• Hydraulic
• Air Impact
• Striking
• Hand Torque
• Ratchets
• Hammers
• Combo Wrench

INSTRUCTIONS
To locate the exact impact socket(s) you need, begin by first choosing either the Metric (mm) or Imperial (inch) measurement system. Next, locate the correct shape you need, then click on the line which shows the square drive size required. This will take you into the main product listing pages where you can explore a vast array of options to choose from.

IMPERIAL-Newton Corp manufactures industrial impact sockets for heavy duty applications. We don’t make chrome hand sockets or any consumer products. We offer an extensive selection of more than 480,000 high quality industrial duty impact sockets; including the largest sizes and deepest stud clearance holes available anywhere, from any maker world wide, and backed by our Lifetime Warranty for most standard designs.

Our non-sparking impact sockets are made heavy duty for impact use, and have been evaluated and certificated by an independent laboratory to comply with applicable ATEX Directives for use in flammable or explosive environments. Our non-sparking impact sockets and wrenches fully comply with applicable requirements for use in Ex gaseous ATEX Zones 0, 1 and 2 as well as ATEX dust Zones 20, 21 and 22 (including both mining specific zones M1 and M2). We offer two types of non-sparking alloys (AlCu and BeCu) along with titanium and stainless for corrosive and magnetic environments.

For over a decade we have produced the largest impact sockets and wrenches anywhere for tackling the world’s largest equipment and machinery applications, some in excess of 190,000 ft-lbs and utilizing our proprietary 4-1/2″ square drive design. If our standard lineup doesn’t meet your needs, we can usually custom make single or multiple impact sockets to get the job done right.

NOTE: If you are not extremely familiar with the various shapes of impact sockets, it may be helpful to know that the vast majority of common nuts and bolts are 6-point, and must therefore only use sockets from either the 6-point or 12-point sections listed below. The other shapes we offer are far less common and are used only for very specific equipment and applications; the rarest of these shapes being the octagon which is listed at the very bottom of this page because it is so uncommon. If you need assistance choosing between the many shapes and lengths we offer, please don’t hesitate to email for technical assistance.

Please begin by choosing either METRIC or IMPERIAL measurement by clicking the appropriate button below.